Stippling

Stippling is the creation of a pattern simulating varying degrees of solidity or shading by using small dots. Such a pattern may occur in nature and these effects are frequently emulated by artists.

In a drawing or painting, the dots are made of pigment of a single colour, applied with a pen or brush; the denser the dots, the darker the apparent shade—or lighter, if the pigment is lighter than the surface. This is similar to—but distinct from—pointillism, which uses dots of different colours to simulate blended colours.

Project Goal:

Create an image using the stippling technique. The subject may we be imagined, from reference, or typographic, but must use both solid consistent values of dot and gradients

Chase & Repousse

Repoussé or repoussage (French pronunciation: [ʁəpuse] ( listen); [ʁəpusaʒ] ( listen) respectively) is a metalworking technique in which a malleable metal is ornamented or shaped by hammering from the reverse side to create a design in low relief. It is a form of toreutics.

There are few techniques that offer such diversity of expression while still being relatively economical. Chasing is the opposite of repoussé, and the two are used in conjunction to create a finished piece. It is also known as embossing.

While repoussé is used to work on the reverse of the metal to form a raised design on the front, chasing is used to refine the design on the front of the work by sinking the metal. The term chasing is derived from the noun “chase”, which refers to a groove, furrow, channel, or indentation. The adjectival form is “chased work”.

Repoussé or repoussage (French pronunciation: [ʁəpuse] ( listen); [ʁəpusaʒ] ( listen) respectively) is a metalworking technique in which a malleable metal is ornamented or shaped by hammering from the reverse side to create a design in low relief. It is a form of toreutics.

There are few techniques that offer such diversity of expression while still being relatively economical. Chasing is the opposite of repoussé, and the two are used in conjunction to create a finished piece. It is also known as embossing.

While repoussé is used to work on the reverse of the metal to form a raised design on the front, chasing is used to refine the design on the front of the work by sinking the metal. The term chasing is derived from the noun “chase”, which refers to a groove, furrow, channel, or indentation. The adjectival form is “chased work”.